Page History
Panel | ||||
---|---|---|---|---|
In this section:
|
Tooltip | ||
---|---|---|
|
Spacevars | ||
---|---|---|
|
Anchor | ||||
---|---|---|---|---|
|
Caption | ||||
---|---|---|---|---|
| ||||
In a dual redundant power supply configuration, the power supplies are hot-swappable meaning that a power supply may be replaced without powering down the
Spacevars | ||
---|---|---|
|
Note | ||||
---|---|---|---|---|
| ||||
Before replacing a power supply in a redundant power supply configuration, verify the status of the redundant power supply. The “POK” LED status must be “solid green”. Removing the power supply when the redundant supply does not show a solid green status, may cause the system to power down. Contact
|
Caption | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
|
Parts and Tools Required
- Electrostatic discharge (ESD) strap
- Replacement AC power supply
Note |
---|
The chassis is shipped with one power supply, unless a second power supply is added to the order. |
Note |
---|
To prevent damage from electrostatic discharge, an ESD strap is provided in the accessory kit. See Connecting ESD Wrist Strap to install it. |
Replacing a Power Supply
Perform the following procedure to replace a power supply:
- Verify the POK green LED of the redundant power supply is lit.
- Attach an Electrostatic Discharge wrist strap to the ESD grounding point on the back panel of the chassis, and place the other end around your wrist (see Connecting ESD Wrist Strap for details).
Disconnect the AC power cable from the AC power supply as shown below.
Caption 0 Figure 1 Disconnecting the AC power cable Disengage the AC power supply by moving the latch to the left as shown below.
Caption 0 Figure 1 Disengaging the AC Power supply Pull on the loop handle to slide the AC power supply out of the
chassis as shown below.Spacevars 0 model5 Caption 0 Figure 1 Disengaging the AC Power supply from the SBC 5000 series chassis - Install the replacement AC power supply into the
chassis by sliding it forward until you hear the latch click in place.Spacevars 0 model5 Reconnect the AC power cable, as shown below.
Caption 0 Figure 1 Reconnecting the AC power cable - Observe that the POK green LED on the newly-inserted power supply is solid green.
- From the application, ensure that no power supply alarms are generated.
CRU Storage
Tooltip | ||
---|---|---|
|
All
Spacevars | ||
---|---|---|
|
The storage environment for these CRUs are:
- Humidity must be less than 95% (non-condensing)
- Temperature must be between -40C and +70C.
Include Page | ||||
---|---|---|---|---|
|
Overview
Content Tools