Page History
Add_workflow_for_techpubs AUTH2 UserResourceIdentifier{userKey=8a00a0c86e0abd6d016e13214f5c0005, userName='null'} AUTH1 UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'} JIRAIDAUTH CHOR-5789 REV5 UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'} REV6 UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'} REV3 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cef30cd0, userName='null'} REV1 UserResourceIdentifier{userKey=8a00a0c86a61778d016a7d0876df0017, userName='null'}
Panel | ||||
---|---|---|---|---|
In this section:
|
Note | ||||||||
---|---|---|---|---|---|---|---|---|
Not applicable to |
Feature Overview
The
includes the Easy Configuration option to add a partially configured signaling group with a new single end-point scenario for ISDN PSTN. Spacevars 0 longproduct
Configure Single Leg Wizard for ISDN PSTN
Info | ||||
---|---|---|---|---|
The Configure Single Leg Wizard for ISDN PSTN option applies to
|
The SBC Easy Configuration interface includes a built-in, step-by-step setup configuration wizard to enable quick and easy deployment of a partially configured signaling group with a new single end-point scenario for ISDN PSTN.
For the single endpoint configuration, since the peer end if not known/configured, in the Easy Configuration Wizard, the Transformation and Routing entries for the endpoint being configured are created independent of the peer end. If you have two endpoints connected and use the Single Leg Wizard to add the third endpoint, you'll need to create/modify the Transformation and Routing entries to complete routing.
Info | ||
---|---|---|
| ||
|
Step 1: Select ISDN PSTN
Easy Configuration Step 1 includes configuration for scenario parameters.
- In the WebUI, click the Tasks tab.
- In the left navigation panel, go to SBC Easy Setup > Easy Config Wizard.
From the Application drop down list, select ISDN PSTN
Configure per the field definitions below and click Next.
Caption 0 Figure 1 Select IP Phones Caption 0 Figure 1 Configure Scenario Parameters - Field Definitions Field Description Application Configuration template used: ISDN PSTN. Scenario Description Name to describe the setup. Telephone Country Country in which the ISDN PTSN endpoint is setup. Provider Type Hardcoded to ISDN.
Step 2: Configure ISDN PSTN for Endpoint
Easy Configuration Step 2 includes configuration for the ISDN PSTN endpoint.
- Configure the ISDN PSTN information.
- Click Next.
Caption | ||||
---|---|---|---|---|
| ||||
The fields below are displayed if you select ISDN/PSTN from the Application drop down list in Step 1.
Caption | ||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||
|
Step 3: Summary
Easy Configuration Step 3 includes a summary of the information configured in Step 1 and Step 2.
Review the information and click Finish.
See below for an example:
Caption | ||||
---|---|---|---|---|
| ||||