Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1
REV5
REV6
REV3
REV1REV2

 

Panel

In this section:

Table of Contents
maxLevel2

Use the licenseMode command to specify the type of licensing that applies to your system. By default license mode is set to legacynodeLocked. This is the only license mode supported on hardware-based systems and is also appropriate for most SWe SBC SWe deployments.

In some OpenStack cloud environments, SBC SWe For a limited number of SWe deployments, the SBC supports a licensing model referred to as network-wide domain licensing (NWDL). If you have arranged to use NWDL, you can use this command to change to domain license mode when you have prepared the system for this type of licensing.  

Note
titleCaution:

The NWDL license bundle must be installed before or at the same time you change the license mode to domain. Changing license modeto domain without a NWDL license bundle installed will result in a service outage. 

Command Syntax

Code Block
languagenone
% set system licenseMode mode <domain | legacy | network>nodeLocked>

Command Parameters

Caption
0Table
1License Mode Parameters
3License Mode Parameters
ParameterDescription
licenseMode mode

Use this parameter to specify the licensing mode for the node:

  • domain - an NWDL deployment. NWDL is supported in a limited number of SWe deployments. Contact your Ribbon representative for more information on licensing options that are available in your environment.
  • legacy nodeLocked(default) - applies to deployments using a node-locked license tied to a specific hardware identifier or node UUID.network - (obsolete) applies only to existing SBC SWe cloud deployments that continue to use network licensing from a prior release. Do not change your license mode to network. New implementations of network licensing are not supported.