Use this object to define ingress IP prefixes. Up to 128 ingressIpPrefix entries may be assigned to a SIP trunk group. Ingress peers matching these ingress IP prefixes are assigned to the specified SIP trunk group.
| Note |
|---|
| As a best practice, always use UPPERCASE for trunk group names. |
Command Syntax
| Code Block |
|---|
|
% set addressContext <name> zone <name> sipTrunkGroup <name> ingressIpPrefix <IP address + prefix>
|
Command Parameters
| Caption |
|---|
| 0 | Table |
|---|
| 1 | SIP Trunk Group Ingress IP Prefix Parameters |
|---|
|
| Parameter | Length/Range | Description |
|---|
ingressIpPrefix | N/A | The ingress peers matching this ingress IP and prefix will be assigned to this SIP trunk group. Enter IPv4 or IPv6 address in the following format:IPv4 – Specifies the V4 IP address in dotted decimal form (for example 10.11.12.0 24).IPv6 – The V6 IP address in hexadecimal/colon form (for example, fd00:21:445:128::7880 64).prefixLength – The number of bits in the address which form the network part of the IP address. The remaining bits (128 – prefix length) specify the host part of the IP address. (range: 0-128).
|
|