This section describes how to prepare for and physically install a Sonus
SBC 1000 system.
Installing the
...
Ribbon SBC 1000 Chassis in an Equipment Rack
The Sonus
SBC 1000 chassis can be installed in a standard 19-inch, 2-post or 4-post equipment rack by attaching the rack mounting ears to the front attachment points on both sides of the chassis.
To Install
...
SBC 2000 in a 2-Post Equipment Rack- Attach the 2 rack mounting ears securely to the front mounting points on both sides of the Sonus SBC 1000 chassis.
Attach the 2 rack mounting ears securely to the mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).
| Panel |
|---|
| bgColor | #FFFFFF |
|---|
| borderStyle | none |
|---|
|
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Install in Equipment Rack |
|---|
| 
|
|
...
After you have completed the physical installation of the Sonus
SBC 1000 chassis, connect the grounding wire and power cables
...
| Warning |
|---|
DO NOT INSTALL EITHER Sonus Ribbon or TELECOM CABLES. You must complete the Initial Configuration before connecting the Sonus Ribbon SBC 1000 system to your network. |
...
You are now ready to complete the initial configuration of the Sonus
SBC 1000 system. Proceed to
Running Initial Setup.
...