Page History
...
The cleanest solution is to configure a single SIP Signaling Group for each network. The SIP SG pointing towards the ISP network should refer to LAN-2 interface. LAN-2 should be placed in ROUTED mode with an IP address in the 10.51.100.89/24 range. The SIP SG pointing to the Enterprise network should use the Application-IP interface, which is the default.
...
| Deck of Cards | ||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||||
|
...
| Panel |
|---|
The previous steps complete the necessary configuration requirements for implementing the Multiple IP feature on SBC Edge 1000/2000. However, if deploying a Sonus SBC SWE Lite, in addition to previous steps perform the following step to complete the Multiple IP feature support on Sonus SBC SWE Lite. |
| Panel | ||||
|---|---|---|---|---|
| Note | ||||
| ||||
All end-points located in a private or public network must be reachable through a next-hop gateway, as driven by the network environment. |
| Panel | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
...
Overview
Content Tools