Versions Compared

Old Version 18

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 19

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Scenario 3 and Scenario 4 are covered in Configuring the SBC Edge for Two CCEs. This document contains steps for Scenario 1 and Scenario 2 deployments.

Multiexcerpt
MultiExcerptNamePreRequisites

Prerequisites

Caption
0Table
1Prerequisites
A public domain name prepared and mapped with your Office 365 tenant (for example, "mydomain.com"). See Create an Office 365 Tenant.
An entry on your public domain name that points to the fixed IP address of your SBC Edge (for example, myccesite1.mydomain.com" with an IP address of "66nn.67nn.68mm.69nn").

An Office 365 tenant with an E5 license or E3 + Cloud PBX.

You must have the Global Administrator role for your O365 tenant account.

A public certificate authority ready to sign a certificate for the SBC Edge.

Important!  Read the steps outlined in Certificate Requirements at Microsoft Technet.

 

A properly configured firewall. See Ports and Protocols at Microsoft Technet.

Note
titleMANDATORY!

Latest System Release SBC Firmware

.

 

Important!

  • Refer to the SBC Edge Release Information page for instructions on obtaining the latest firmware.
  • Failure to update to the latest firmware could lead to deployment failure.
  • Make sure to use the latest sustaining release (use 6.1.2 rather than X.X.0, for example).
Note
titleMANDATORY!

Latest System Release SbcComms Firmware

.

 

Important!

  • Refer to the SBC Edge Release Information page for instructions on obtaining the latest firmware.
  • Failure to update to the latest firmware could lead to deployment failure.
  • Make sure to use the latest sustaining release (use 6.1.2
 
  • rather than X.X.0, for example).


 

Microsoft Cloud Connector Edition image on ASM recovery partition.

...

StepAction
1Login to the WebUI of the SBC Edge.
2Open the Tasks tab and click Setup Cloud Connector Edition in the navigation pane.
3Click the Prepare CCE tab.
4

Click the Prepare CCE button. Enter the requested password. A confirmation will request you to enter the password again for the new password. Only the Tenant credentials are already existing. Click OK as shown below.

5

To complete the deployment, continue with installing the CCE Appliance using the Sonus Cloud Link Deployer. 

...

After the CCE is deployed, integrate the  Sonus SBC Edge and allow calls from/to O365 clients. In this example, the following steps will set up the Sonus SBC Edge for:

 

SIP Provider (193NNN.168NNN.210NNN.103NNN) – SBC Edge (193NNN.168NNN.210NNN.125NNN)  – CCE (mediation Server: 193NNN.168NNN.210NNN.123NNN) – O365 Cloud

 

Build your SBC configuration

...

StepAction
1

On the WebUI, run Preparing the CCE to specify a new Password. Select the existing password and enter the new password. Only the O365 should be modified for a running instance of CCE.

2On Remote desktop, start the Sonus Cloud Link Deployer, and check Transfer Password from SBC to reset the credentials.

  

Pagebreak