Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 3

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Add_workflow_for_techpubs
AUTH1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
JIRAIDAUTHCHOR-264
REV5UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
REV6UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
REV3UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cc9e087c, userName='null'}
REV1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cc7d083d, userName='null'}

Panel

In this section:

Table of Contents
maxLevel4

This section describes 

Spacevars
0series3
 hardware and software requirements and recommendations.

To install and configure 

Spacevars
0series3
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.

 

Warning
iconfalse

The recommended hardware and software settings are intended to ensure optimum stability and performance. If the recommended settings are not used, the

Spacevars
0series3
may not behave as expected.

License Requirements

You must obtain and apply a valid

Spacevars
0product3
 license in order to configure and use the 
Spacevars
0product3
. See the instructions at Obtaining and Installing a SWe Lite License.

Server Hardware Requirements

 

Caption
0Table
1Server Hardware Requirements
Configuration Requirement
Processor2nd Generation Intel Core or Intel Xeon Processor (Sandy bridge or later)
RAMRAM requirements are dependent upon the number of VMs hosted, the memory assigned to each VM instance, and the relative overhead memory associated with each.
Drive Space
Hard disk requirements are dependent upon the number of VMs hosted, the size of each VM at full size, and whether checkpoints will be enabled.
Architecture64-bit Intel processor
Host OS
Microsoft Windows Server 2012

 

Minimum Hyper-V hosting requirements are posted by Microsoft.

BIOS Setting Recommendations

Sonus recommends the following BIOS settings for optimum performance:

Caption
0Table
1Recommended BIOS Settings for Optimum Performance
BIOS ParameterRecommended
Setting		Details
Intel VT-x (Virtualization Technology)EnabledFor hardware virtualization
Intel Hyper-ThreadingEnabled 

 

 

Note
iconfalse

BIOS settings and recommendations must not be changed once it is applied on the server.

Sonus Recommendations for
Spacevars
0series3

General Recommendations

  • Plan enough resources (RAM, CPU, NIC ports, hard disk, etc.) for all the virtual machines (VMs) to run on server platform, including resources needed by Hyper-V itself.
  • Allocate each VM with only as much virtual hardware as that VM requires. Provisioning a VM with more resources than it requires can, in some cases, reduce the performance of that VM as well as other virtual machines sharing the same host.

  • Disconnect or disable any physical hardware devices (Floppy devices, Network interfaces, Storage controllers, Optical drives, USB controllers, etc.) under BIOS settings that you will not be using to free up interrupt/CPU resources.

Caption
0Table
1VM Configuration Recommendations
SettingMinimum
vCPU1
RAM

1 GB

vNIC5
Virtual Hard Disk5 GB
 

Additional Information

  • The SBC SWe Lite VM does not currently support allocation of more than one vCPU.
  • With minimum RAM allocation, the maximum SIP endpoint registrars is 1000, and the maximum number of concurrent calls is 100.
  • The estimated Hyper-V overhead memory for each SBC SWe Lite VM is 32MB.
  • Minimal networking configuration requires the Management Network Interface and at least one Media Interface to be assigned.
  • Each SBC SWe Lite VM will use approximately 5GB of Virtual Hard Drive space. Drive size is predetermined by the imported image.

 

Info
iconfalse

Refer to Downloading the SBC SWe Lite Package for software download instructions.

 

Pagebreak