Include Page | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||
| ||||||||||||
| ||||||||||||
| ||||||||||||
|
Panel | ||||||
---|---|---|---|---|---|---|
In this section:
|
...
This technical guide shows how to configure the SBC Edge with a Tenor AF/AX for fax connection.
This document provides basic guidelines, and assumes the user has a working knowledge of the following products:
Deployed software versions in this document are:
...
Basic configuration information for these products can be found in the Best Practices section.
...
Spacevars | ||
---|---|---|
|
Note |
---|
This procedure detailing configuration of the SBC 1000/2000 and Tenor AFM200 assumes configuration in the country of France using G711A / G.711A / a-law. Other countries such as USA and Japan use the corresponding G711U / G.711U / µ-Law. Verify you are using the proper protocol for the country in which the configuration is taking place. |
...
Perform the steps below to configure the SBC 1000/2000 for the interconnection scenario.
Use the SBC 1000 web interface and search for the objects below to help with navigation.
...
...
...
Create a dedicated transformation table to be able to receive a fax on the SBC 1000 and forward it to the Tenor, depending on the fax numbers to be routed from the SBC 1000 to Tenor.
Info |
---|
For example, to route all calls from extension range 1xxx to Tenor, enter similar data in the Description field as shown in figure below. |
...
Verify the fax section of the IP Routing Group menu is configured as shown below, and matches what was created on the SBC 1000/2000 for the T.38 codec:
Panel | |||||||
---|---|---|---|---|---|---|---|
| |||||||
|
...
These tables only look for and can adapt the called number in the above example, but you can also adapt the calling number.
Pagebreak |
---|