Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Click the Create Media List ( ) icon at the top of the Media List View page.

    Panel
    borderStylenone

    Caption
    0Figure
    1Create Media List

    Image RemovedImage Added

Anchor
properties
properties

...

Panel
bgColor#FAFAFA
borderStylenone

Specifies where or not to use Voice Activity Detection and send PT13 packets when on.

  • If Silence Suppression is enabled, the Sonus SBC 1000/2000 the 
    Spacevars
    0product
    monitors outgoing audio (towards the IP network). If silence is detected, voice packet transmission will cease to save network bandwidth. The enable setting saves network bandwidth, however, voice quality may be slightly degraded.
  • If Silence Suppression is disabled, voice packets are sent regardless of whether or not audio is present.

...

Panel
bgColor#FAFAFA
borderStylenone

Specifies whether or not modem passthrough is enabled when using the G.711 codec.

If the user wants to support modem calls, this option should be Enabled. When Disabled, the Sonus SBC 1000/2000 the 

Spacevars
0product
does not distinguish between voice and modem calls. When Enabled, and the Sonus SBC 1000/2000 the 
Spacevars
0product
detects a modem call, it switches to Modem Passthrough mode (based on G.711 codec).

...

Panel
bgColor#FAFAFA
borderStylenone

Controls whether or not the Sonus SBC 1000/2000 the 

Spacevars
0product
supports G.711 faxing.

  • If you wish to force fax calls to use G.711 (uLaw/aLaw) codec, then Fax Passthrough must be Enabled. Also, G.711 must be the only codec in the Sonus SBC 1000/2000 Media List. In this configuration, the Sonus SBC 1000/2000 the 
    Spacevars
    0product
    will only offer/accept G.711 in the reINVITE.
  • If you wish to support both G.711 and T.38 faxing simultaneously, the Fax Passthrough must be Enabled, and the Sonus SBC 1000/2000 the 
    Spacevars
    0product
    must be configured with both G.711 and T.38 codecs. Which faxing type is selected will depend upon the codecs offered/accepted in the reINVITE.
  • If you wish to force fax calls to use T.38 codec, configure the Fax Passthrough to Disable. Sonus SBC 1000/2000 The 
    Spacevars
    0product
    must be configured for both G.711 and T.38 codecs. In this configuration, the Sonus SBC 1000/2000 the 
    Spacevars
    0product
    will only offer/accept T.38 in the reINVITE.
Info
iconfalse

If your fax destination only offers T.38 in the reINVITE, then the Sonus SBC 1000/2000 the 

Spacevars
0product
must be configured for both G.711 and T.38. As noted above, T.38 fax negotiation is possible with Fax Passthrough configured to either Enable or Disable.

...

Panel
bgColor#FAFAFA
borderStylenone

Specifies whether or not the Sonus SBC 1000/2000 system the 

Spacevars
0product
will detect Fax tones produced by the origination side fax machine. CNG tone detection is used when Fax calls are received from TDM to a Fax server and the voice call needs to be switched to a Fax call using T.38. If CNG tone detection is enabled, the 
Spacevars
0product
detects the Fax tone from TDM and switches to Fax mode (it will initiate a re-INVITE with T.38 support to the Fax Server). If CNG tone detection is disabled, the 
Spacevars
0product
will pass-through the Fax tones to the Fax server and the Fax server will have to detect them and initiate a re-INVITE to switch to Fax mode with T.38.

Fax Tone Detection

Panel
bgColor#FAFAFA
borderStylenone

Specifies whether or not the Sonus SBC 1000/2000 system will detect Fax tones produced by the terminating side fax machine. Fax tone detection(V.21 flags) is used when Fax calls are received from TDM to a Fax server and the voice call needs to be switched to a Fax call using T.38. If Fax tone detection is enabled, the 

Spacevars
0product
detects the Fax tone from TDM and switches to Fax mode (it will initiate a re-INVITE with T.38 support to the Fax Server). If CNG Fax tone detection is disabled, Sonus SBC 1000/2000 the 
Spacevars
0product
will pass-through the Fax tones to the Fax server and the Fax server will have to detect them and initiate a re-INVITE to switch to Fax mode with T.38.

...