Not supported by SBC SWe Lite in this release.

This article describes the configuration of Valcom.

On Using Tenor as an Analog Device in a Lync SBC SBA Deployment page we described the analog endpoints configuration for Lync - SBC1(or 2) K - Tenor setup. If Valcom paging devices are desired to be used as the analog endpoints, further configuration is needed on Valcom side.

For the Lync analog endpoint configuration, an analog endpoint had to be created using the Lync Management Shell as:

New-CsAnalogDevice -LineUri tel:+15102462001 -DisplayName "Analogph1" -RegistrarPool cspool.uxdemo.net -AnalogFax $false -Gateway 
ux246.uxdemo.net -OU "ou=Analog,dc=uxdemo,dc=net"

and on Tenor point of view, we had to  configure the relevant endpoint as shown below (for further steps on Tenor side configuration please refer to Using Tenor as an Analog Device in a Lync SBC SBA Deployment) :

Configure Endpoint

 

If we need the actual analog endpoints as Valcom paging devices, following steps has to be completed on Valcom side.

Launch the Valcom IP Solution Setup Tool and connect to the paging device as shown below (for further details of Valcom IP Solution Setup Tool manual):

Configure desired name and IP address for your device as shown below:

Analogph1

 

Analogph1 Properties

Analogph1 Network

 

 

Following depicts the Properties of the device:

Analogph1 Summary

 

Now configure the dial code (extension number) for your endpoint as shown:

Analogph1 Dial Code

Analogph1 Relays