In this section:


Overview

The SBC SWe Edge includes the Easy Configuration option to add a partially configured signaling group with a new single end-point scenario for IP Phones.

The Configure Single Leg Wizard for IP Phones option only applies to SBC SWe Edge.

The SBC Easy Configuration interface includes a built-in, step-by-step setup configuration wizard to enable quick and easy deployment of a partially configured signaling group with a new single end-point scenario for an IP Phone.

For the single endpoint configuration, since the peer end if not known/configured, in the Easy Configuration Wizard, the Transformation and Routing entries for the endpoint being configured are created independent of the peer end. If you have two endpoints connected and use the Single Leg Wizard to add the third endpoint, you'll need to create/modify the Transformation and Routing entries to complete routing.

Easy Configuration Wizard - Single Leg Configuration Notes
  • Use the single leg wizard to add a 3rd, 4th, or 5th peer to a device, when at least two legs are already configured via the standard Easy Configuration Wizard.
  • Emergency configuration is not supported for single end scenarios.

Procedure

Step 1: Select IP Phones

Easy Configuration Step 1 includes configuration for scenario parameters.

  1. In the WebUI, click the Tasks tab.
  2. In the left navigation panel, go to SBC Easy Setup > Easy Config Wizard.
  3. From the Application drop down list, select IP Phones.

  4. Configure per the field definitions below and click Next.


    Configure Scenario Parameters - Field Definitions

    FieldDescription
    ApplicationConfiguration template used: IP Phones.
    Scenario DescriptionName to describe the setup.
    Telephone CountryCountry in which the IP Phone is setup.
    SIP SessionsNumber of simultaneous SIP Sessions. Valid entry: 1 - 960.
    Teams ConnectionHardcoded as IP Phone Registrar as user type.

Step 2: Configure IP Phone for Endpoint

Easy Configuration Step 2 includes configuration for the IP Phone endpoint.

  1. Configure the IP phone information.
  2. Click Next.


The fields below are displayed if you select IP Phones  from the Application drop down list in Step 1. 

Configure Teams Direct Routing

FieldDescription
IP Phone Numbering PlanIP phone numbering plan to be used. Valid options: E.164, National, or Extension.
Number PrefixFirst set of digits. Only available if IP Phone Numbering Plan is configured as Extension.
Extension Length

Number of digits used to account for the PSTN extension. Valid options: 2, 3, 4, or 5. This field is available only when IP Phone Numbering Plan is set to  Extension.

Number of UsersDefine the number of users. Valid entry 1 - 1000.
ProtocolProtocol used for communicating with the IP phone.  Valid entry: UDP or TCP.
Port NumberPort Number used for sending and receiving messages between SBC and the IP phone. Default entry: 5060.
IP Phone Network Addresses

Configure a network address and Netmask for the host or subnet in which the IP phone resides.

Network IP. IP address for the destination host or subnet in which the IP phone resides.

Netmask. The network mask of the destination host or subnet in which the IP phones resides.

To create a network address, click the green "+" icon.  Enter the Network IP and Network Mask and click OK.


Step 3: Summary

Easy Configuration Step 3 includes a summary of the information configured in Step 1 and Step 3.

Review the information and click Finish.

Example: