ASM Behavior on Ribbon SBC 1000/2000 Reboot Operation
  • SBC 2000
  • If the ASM is running, rebooting the SBC will cause the ASM to also reboot.
  • If the ASM is shut down, rebooting the SBC will not restart the ASM.
  • To bring the ASM back into operation, you must physically power off and power back on the SBC.
  • SBC 1000 --- rebooting the SBC will reset the Ethernet port which could create an unreachable state for the ASM — this state lasts only a few seconds.


Rebooting the Ribbon SBC Edge Portfolio

To reboot the SBC Edge Portfolio system:

  1. In the WebUI, click the Tasks tab.
  2. In the left navigation pane, under the System, click Reboot SBC Edge Portfolio

  3. Click OK

  4. When you receive the confirmation message, click OK to reboot the system.
  5. The web interface will dispatch the following status message throughout the reboot cycle.

On average, the Ribbon SBC 1000/2000 system takes between 3 to 4 minutes to fully reboot and become reachable again through the web interface.

Upon completion, you will be automatically redirected to the Login Screen