Applies to SBC Edge 1000 - 2000 only.

The Modify Default VLAN task enables you to modify the VLAN used as the default on the selected port. You can either select an existing VLAN or create a new one. The IP address from the existing VLAN will be migrated to the new default VLAN in the cases listed below.

  • If the new VLAN interface does not have an IP address configured, the IP will be migrated from the previous VLAN.
  • If the Default VLAN being modified is used by another port (except the ASM port), the IP address will not be migrated.
  • If the selected Port and the ASM Port are configured with the same Default VLAN, then modifying the Default VLAN on the selected Port will change the ASM Port's Default VLAN as well.

Set the default VLAN as follows:

  1. In the WebUI, click the Tasks tab.

  2. In the left navigation pane, under IP/Protocols, click Modify Default VLAN.

  3. Edit the Default VLAN ID Setup information as necessary.
  4. Click Apply.


Default VLAN ID Setup - Field Definitions

Port

The port in which the selected VLAN will be configured as the Default VLAN. Valid entry: select from the drop down list of available ports.


VLAN Selection

Determines whether an existing or new VLAN is used as the Default VLAN. Valid entry: Select Existing VLAN (you select an existing VLAN as the default), or Create New VLAN (you create a new VLAN as the default). If you select Create New VLAN, the following fields are displayed: VLAN ID, VLAN Description, MST Instance. When a new VLAN is created, it is added to the Logical Interfaces table. See Managing Logical Interfaces.

VLAN ID

An integer value that identifies the VLAN and is used in assigning port membership. Valid entry: 2 - 3999.

VLAN Description

A description of the VLAN (e.g. Traffic VLAN, Ribbon VLAN, etc.). This field is available only when Create New VLAN is selected from VLAN Selection.

MST Instance

Specifies the list of available Multiple Spanning Tree (MST) Instances. For more information about MST, see Working with Multiple Spanning Trees. Valid entry: select from the drop down list. This field is available only when Create New VLAN is selected from VLAN Selection.

Default Untagged VLAN

Specifies the list of existing VLANs associated with this port. This list is populated with the entries in the VLAN Table. See Managing VLANs - SBC 1000-2000. Valid entry: select an entry from the drop down list.  This field is available only when Select Existing VLAN is selected from VLAN Selection.



  • No labels