Note

This object is visible only for distributed SBC (D-SBC) deployments.


Use this the Dsbc Sig Port window to configure the D-SBC signaling ports for the IP Interface Group used to communicate between the signaling, media, and transcoding SBCs in a deployment.

Note

You must configure Cluster Admin for intra-cluster node communication before configuring a D-SBC signaling port, Load balancing service and DNS group parameters.

From the SBC main screen, go to All > System > Dsbc > Dsbc Sig Port.

The Dsbc Sig Port window opens.

Dsbc Sig Port Window


Note:

Make sure when configuring SIP signaling ports and D-SBC signaling ports for an S-SBC deployment that you specify different IP addresses for them. To do so you must select different metavariables for each of them. The actual values of the metavariables are determined during orchestration of your deployment.

Use the following table to configure the parameters and then click Save.

ParameterDescription
Type

The interface type supported by the D-SBC.

  • IP (default)
IP Interface GroupThe name of the IP Interface Group to use for D-SBC communication.
Address ContextThe name of the address context containing the D-SBC IP Interface Group.
IP Var V4The name of the configuration variable to get the IPv4 address for this D-SBC signaling port.
IP Public Var V4The name of the configuration variable to get the public/floating IPv4 address for this DSBC signaling port.
IP Var V6The name of the configuration variable to get the IPv6 address for this D-SBC signaling port.
IP Public Var V6The name of the configuration variable to get the public/floating IPv6 address for this DSBC signaling port.
Transport TypeThe transport type to use for the D-SBC signaling link.
Encryption Type

The encryption type used in the D-SBC signaling link.

  • None (default)
Mode

The D-SBC signaling port mode.

  • In Service
  • Out Of Service (default)
State

The state of the D-SBC signaling listener port.

  • Disabled (default)
  • Enabled


  • No labels