Use this procedure to configure the AWS SBC SWe G3 Instance for transcoding.
set system sweCodecMixProfile customCodecMix <codec_a> p20 percentage <percent_codec_a> set system sweCodecMixProfile customCodecMix <codec_b> p20 percentage <percent_codec_b> . . . set system sweTrafficProfiles <traffic_profile> transcodingCodecProfile customCodecMix set system sweActiveProfile name <traffic_profile>
Where:
standard_gpu_isbc_profile
(personality type is ISBC)set system sweCodecMixProfile customCodecMix amrwb p20 percentage 50 set system sweCodecMixProfile customCodecMix g729 p20 percentage 50 set system sweTrafficProfiles standard_gpu_isbc_profile transcodingCodecProfile customCodecMix set system sweActiveProfile name standard_gpu_isbc_profile
5. The instance goes for a reboot, and comes up in the required profile, which can be checked using the following command:
admin@vsbc1> show table system sweActiveProfile name standard_gpu_isbc_profile; stateChangeTime 2018-04-22T02:41:41-00:00; [ok][2018-04-23 03:21:04] admin@vsbc1>
6. Once the load is run to check the number of calls running on the GPU, use CLI command.
This command will the number of calls running on the GPU.
admin@vsbc1> show table system gpuTranscodeStatus G729 AMR AMR SYSTEM GPU AB G729 AB NB AMR NB WB AMR WB EVRCB0 EVRCB0 EVRC0 EVRC0 G722 G722 NAME NUMBER TOTAL UTILIZATION TOTAL UTILIZATION TOTAL UTILIZATION TOTAL UTILIZATION TOTAL UTILIZATION TOTAL UTILIZATION --------------------------------------------------------------------------------------------------------------------------------------------- vsbcSystem 1 0 0 0 0 1536 52 0 0 0 0 0 0 [ok][2018-05-02 14:19:06] admin@vsbc1>