In this section:

Related articles:

Note

Applicable only for CALEA users

Overview

This section briefly describes the commands for configuring LI on M-SBC.

Note
  • As a prerequisite to configure LI (any supported variety) on S-SBC, ensure that the Call Data Channel (CDC) and the Mediation Server are enabled and running.
  • You can configure LI using default address context only.
  • For more information on the parameters and their descriptions, refer to Intercept - CLI.

 

Configure Default LI on M-SBC

% set addressContext default intercept callDataChannel <CDC Name> 
    interceptStandard <Default LI supported Value> 
    vendorId <Default LI Supported Values>
Note

For Default/Legacy LI on the M-SBC, ensure that the LIF group name used to send the X3 intercepted data is the same as the interface name in the S-SBC (used to send the X2 data on the S-SBC).

 

Configure IMS LI on M-SBC

To configure IMS LI on M-SBC, configure the Media (X3) interface using the two commands shown below:

Tip

Perform a commit after each step.

% set addressContext default intercept callDataChannel <CDC Name> 
    interceptStandard <IMS LI flavor> 
    vendorId <IMS LI Falvour> 
    mediaIpInterfaceGroupName <LIG1 from where data is sent>

% set addressContext default intercept callDataChannel <CDC Name> 
    mediationServer <mediation server name> media <transport type> 
      ipAddress <ip address of mediation server> 
      portNumber <port number of mediation server>

Configure PSCI LI on M-SBC

Tip

Perform a commit after each step.

% set addressContext default intercept callDataChannel <CDC Name> 
    interceptStandard <PSCI LI supported value> 
    vendorId <PSCI LI supported value> 
    mediaIpInterfaceGroupName <LIG1 from where data is sent>

% set addressContext default intercept callDataChannel <CDC Name> 
    mediationServer <mediation server name> media <transport type> 
      ipAddress <ip address of mediation server> 
      portNumber <port number of mediation server>


# To activate:
set addressContext default intercept callDataChannel <CDC Name>
	mediationServer <mediation server name> media <transport type> 
	state enabled 
	mode inService