In this section:
The Logical Management IP Interface is a virtual management IP interface configurable using CLI syntax described in this section.
A Logical Management Interface must include both physical management interfaces. Therefore, it should contain all four interfaces. Otherwise, this will result in a confd
restart and ahealthcheck timeout
(system down time) if the physical interface underlying the logical interface goes down.
set system logicalMgmtIpInterface <intfc_name> ipAddress <ip address> mgmtIpInterfaceGroupName <name> state <disabled | enabled> useIpAddrAsSnmpSource <false | true>
Logical Management IP Interface
Parameter | Description |
---|---|
| The logical management IP interface name. |
| The logical IP address of the interface. The following IP address types are supported:
|
| The name of the management IP interface group used by this logical IP interface. |
| Administrative state of the logical management IP interface.
|
| Set this flag to “true” to receive SNMP requests on this logical management IP address, and to use this address as the source for SNMP responses, alarms and traps.
NOTE: This flag can only be enabled on one logical management interface at a time. |
To display the logical management IP interface configuration:
% show system logicalMgmtIpInterface LogMgmt mgmtIpInterfaceGroupName mgmtGroup; ipAddress 3FFE:1900:4545:3:200:F8FF:FE21:67CF; state enabled; useIpAddrAsSnmpSource true;
To display the logical management IP interface configuration for two subnets:
% show system logicalMgmtIpInterface logicalMgmtIpInterface AGMGM { mgmtIpInterfaceGroupName mgmtGroup1; ipAddress 10.54.67.50; state enabled; useIpAddrAsSnmpSource disabled; } logicalMgmtIpInterface HAMGM { mgmtIpInterfaceGroupName mgmtGroup; ipAddress 10.54.66.65; state enabled; useIpAddrAsSnmpSource disabled; }
When configuring the management interfaces on two subnets, a logical management IP interface is needed for each subnet.