In this section:

This object is used to configure Relay Port parameters.

To View Relay Port

On SBC main screen, navigate to All > Address Context > Zone > Relay Port. The Relay Port can be checked for each Address Context and Zone or for all the Address Contexts and Zones created. Use the drop-down box to select the desired Address Context and Zone.

Relay Port Main Field

 

 

The Relay Port window is displayed

Relay Port

 

To Edit Relay Port

To edit any of the Relay Port in the list, click the radio button next to the specific Relay Port name.

Relay Port Highlighted

 

 

The Edit Selected Relay Port window is displayed below.

Relay Port Edit Window

 

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create Relay Port

To create a new Relay Port, click New Relay Port tab on the Relay Port List panel.

Relay Port Fields

 

 

The Create New Relay Port window is displayed.

Relay Port Create Window

 

 

The following fields are displayed:

Relay Port Parameters

 

Parameter

Description

Index

The index of this Relay Port. Range 1-4000.

Each Relay Port index must be unique across all zones.

Up to 512 relay ports are configurable per zone, and up to 1,000 system-wide.

Mode

The operational mode for this Relay Port. Options are:

  • Out Of Service (Default)
  • In Service

State

The administrative state of the Relay Port.

  • Disabled (Default)
  • Enabled

IP Interface Group Name

IP interface group used by this Relay Port.

Relay Profile

Enter the Relay Profile used by this Relay Port.

IP Address V4 or V6 

The IPv4 or IPv6 address of the interface for this Relay Port.

Port Number

TCP listener port number to use for this relay. Range is 1 to 65535.

Transport Protocols Allowed

The transport protocol allowed on relay port.

tcp is the only option in this release

To Copy Relay Port

To copy any of the created Relay Port and to make any minor changes, click the radio button next to the specific Relay Port to highlight the row.

Relay Port Highlighted

 

 

Click Copy Relay Port tab on the Relay Port List panel.

Relay Port Fields

 

 

The Copy Selected Relay Port window is displayed along with the field details which can be edited.

Relay Port Copy Window

 

 

Make the required changes to the required fields and click Save to save the changes. The copied Relay Port is displayed at the bottom of the original Relay Port in the Relay Port List panel.

To Delete Relay Port

To delete any of the created Relay Port, click the radio button next to the specific Relay Port which you want to delete.

Relay Port Highlighted

 

 

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Relay Port Delete Confirmation

 

 

Click Yes to remove the specific Relay Port from the list.

Note

Sub-system signaling ports (such as SIP signaling ports, relay ports, D-SBC signaling ports, H.323 signaling ports) must use different IP addresses because each IP address adds one system ACL, and IP addresses are not prioritized when measured in the same ACL. This best practice will avoid any IP addressing overlaps and ensure proper policing of packets.

  • No labels