In this section:

 

SBC 5000 series applies disconnect treatment to the ingress party specified by the Signaling Sequence Profile (SSP). This SSP is derived from the SCP disconnect treatment profile (DTP) and disconnect treatment indicator provided by the PSX in a trigger response.

The DTP must be explicitly configured on the SBC 5000 series. The existing disconnect reason is still forwarded to the ingress party immediately after the disconnect treatment (if applicable) is applied. The disconnect reason can be SCP or egress party initiated.

To View Disconnect Signal Sequence Profile

On SBC main screen, go to Configuration > Profile Management > Category: Service Profiles > Disconnect Signal Sequence Profile.

The Disconnect Signal Sequence Profile window is displayed.

Profile Management - Service Profiles - Disconnect Signal Sequence Profile

To Edit Disconnect Signal Sequence Profile

To edit any of the Disconnect Signal Sequence Profile in the list, click the radio button next to the specific Disconnect Signal Sequence Profile name.

Profile Management - Service Profiles - Disconnect Signal Sequence Profile Highlighted

The Edit Selected Disconnect Signal Sequence Profile window is displayed below.

You would not be able to edit as the field is read-only.

To Create Disconnect Signal Sequence Profile

To create a new Disconnect Signal Sequence Profile, click New Disconnect Signal Sequence Profile tab on the Disconnect Signal Sequence Profile List panel.

Profile Management - Service Profiles - Disconnect Signal Sequence Profile Fields

The Create New Disconnect Signal Sequence Profile window is displayed.

Profile Management - Service Profiles - Disconnect Signal Sequence Profile Create Window

The following fields are displayed:

Disconnect Signal Sequence Profile Parameters

ParameterDescription
Name Specifies the user name for this Disconnect Signal Sequence Profile.

To Delete Disconnect Signal Sequence Profile

To delete any of the created Disconnect Signal Sequence Profile, click the radio button next to the specific Disconnect Signal Sequence Profile which you want to delete.

Profile Management - Service Profiles - Disconnect Signal Sequence Profile Highlighted

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Profile Management - Service Profiles - Disconnect Signal Sequence Profile Delete Confirmation

Click Yes to remove the specific Disconnect Signal Sequence Profile from the list.

  • No labels