In this section:
Ribbon-provided SFP modules must be used to guarantee proper operation of the external ports. Failure to follow this recommendation may cause permanent damage to the system.
The SBC 5000 series supports the following Small Form-factor Pluggable (SFP) transceivers in all the Media and HA ports. The SFPs are Customer Replaceable Units (CRU).
SFP Characteristics
Transceiver Type | Product Code | SFP Type | Manufacturers Part Number | Wavelength (nm) | Tx Power (dBM) | Rx Power (dBM) | Description | ||
---|---|---|---|---|---|---|---|---|---|
Multi-mode fiber | SBC‐5XXXSFPMM | 1G Ethernet |
| 850 | -9.5 (Min) | -3 (Max) | -17 | 0 | GIG-E, MULTI-MODE, FIBER OPTIC TRANSCEIVER MODULE, LC, SMALL FORM PLUGGABLE (SFP), 300M |
Single-mode fiber | SBC‐5XXXSFPSM | 1G Ethernet SM |
| 1310 | -9.5 (Min) | -3 (Max) | -19 | -3 | GIG-E, SINGLE MODE, FIBER OPTIC TRANSCEIVER MODULE, LC, SMALL FORM PLUGGABLE (SFP), 10KM 1310NM, DMI |
Copper | SBC-5XXX-SFPCOPPER | 1G Ethernet Copper |
| n/a | n/a | n/a | n/a | n/a | GIG-E, 1000 BASE-T SMALL FORM PLUGGABLE (SFP) |
These numbers are taken from Vendor Datasheets.
To replace SFPs, use the procedure Replacing the SFP below.
SFP Ports
Perform the following procedure to replace the SFP:
Disconnect the fiber optic and/or Cat 5 cables, as appropriate, from media ports (Media 0-4) and HA ports (HA 0-1).
Disengage the SFP transceiver from SBC 5000 series. The method used to disengage the SFP transceiver will vary according to the manufacturer. For example, hold the wire latch and move it downwards to the horizontal position and pull it outwards, as shown below.
The SBC 5200 chassis contains four media ports and the SBC 5100 chassis two media ports.
Removing SFP
Inserting SFP
Insert the Ribbon-approved SFP transceiver into the desired socket and ensure that the latch mechanism engages.
All SBC 5000 series CRUs are shipped in electrostatic discharge bags and should be handled using appropriate ESD precautions.
The storage environment for these CRUs are:
The ESD Susceptibility symbol Ribbon devices susceptible to electrostatic discharge. Do not handle equipment without wearing a properly grounded ESD wrist strap.
warns of the presence of