In this section:
Use this command to configure the D-SBC signaling ports for the IP Interface Group used to communicate between the signaling, media and transcoding SBCs.
The D-SBC Signaling Port configuration syntax, parameter descriptions and command examples are included in this section.
You must configure Cluster Admin before configuring D-SBC Signaling Port, Load Balancing Service and DNS Group parameters for intra-cluster VNFC communication.
Refer to Cluster Admin - CLI for configuration details.
% set system dsbc dsbcSigPort addressContext <addressContext name> encryptionType <none> ipInterfaceGroup <IPIG name> ipPublicVarV4 <metaVariable> ipPublicVarV6 <metaVariable> ipVarV4 <metaVariable> ipVarV6 <metaVariable> mode <inService | outOfService> state <disabled | enabled> timers <keepalive | retry> transportType <tcp> type <ip>
DSBC Sig Port Parameters
Parameter | Length/Range | Description |
---|---|---|
addressContext | N/A | <addressContext name> – The name of the address context to use for the D-SBC IP Interface Group. |
encryptionType | N/A | The encryption type used in the D-SBC signaling link.
|
ipInterfaceGroup | N/A |
|
ipPublicVarV4 | 1-255 characters | <metaVariable> – The name of the metaVariable used to fetch the public/floating IPv4 address. |
ipPublicVarV6 | 1-255 characters | <metaVariable> – The name of the metaVariable used to fetch the public/floating IPv6 address. |
ipVarV4 | 1-255 characters | <metaVariable> – The name of the metaVariable used to fetch the IPv4 address. |
ipVarV6 | 1-255 characters | <metaVariable> – The name of the metaVariable used to fetch the IPv6 address. |
mode | N/A | The D-SBC Signaling Port mode.
|
state | N/A | The state of the D-SBC Signal Listen Port.
|
timers | N/A | Use this parameter to configure keep-alive and retry timers related to recovering a D-SBC signaling link when stable calls are present.
NOTE: Before changing the D-SBC timer value, disable |
transportType | N/A | The transport type used for D-SBC signaling link.
|
type | N/A | The interface type supported by the D-SBC.
|
To configure D-SBC Signaling Port:
set system dsbc dsbcSigPort addressContext default ipInterfaceGroup LIG1 type ip ipVarV4 IF2.IPV4 mode inService state enabled commit
show details system dsbc dsbcSigPort type ip; ipInterfaceGroup LIG2; addressContext default; ipVarV4 IF3.IPV4; ipPublicVarV4 IF3.FIPV4; transportType tcp; encryptionType none; mode inService; state enabled; timers { keepalive 3; retry 1; } [ok]
To disable D-SBC Signaling Port:
set system dsbc dsbcSigPort mode outOfService state disabled commit
To set the values of the keep-alive and retry timers to "3" and "20" seconds, respectively :
set system dsbc dsbcSigPort timers keepalive 3 retry 20 commit
To enable D-SBC Signaling Port:
set system dsbc dsbcSigPort mode inService state enabled commit
To view the keep-alive timer value:
show table system dsbc dsbcSigPort timers keepalive keepalive 3;
To view the retry timer value:
show table system dsbc dsbcSigPort timers retry retry 20;