In this section:

The Trap Table identifies the SNMP notifications that this node supports.

To View Traps - Admin

On SBC main screen, go to Administration > Traps and SNMP > Traps > Admin. The Admin window is displayed.

Figure 1: Traps - Admin Window

By default only ten entries are displayed in a view. You can choose the number of entries to be displayed under the Show entries drop down box. 

To Edit Traps - Admin

To edit any of the Traps - Admin, click the radio button next to the specific Trap name.

The Edit Selected Admin window is displayed below.

Figure 2: Traps - Admin Edit Window

Make the required changes and click Save to save the changes. You can click Show only required fields at the left hand bottom of the panel to view and enter only the required fields.

The following fields are displayed:

Table 1: Admin

Parameter

Description

Name

Specify the name of the trap.

State

The administrative state of this trap.

  • disabled (default)—Off. In this state the trap message is not sent to a management client.
  • enabled—On. In this state the trap message will be sent to all properly registered and authenticated management clients.
Priority level

Specifies the current priority level of the event/trap/alarm.

The options are:

  • default (default): Use the manufacturer default priority level for this particular event/trap/alarm.
  • critical: Assign the critical priority level to this event/trap/alarm.
  • major: Assign the major priority level to this event/trap/alarm.
  • minor: Assign the minor priority level to this event/trap/alarm.
  • info: Assign the info priority level to this event/trap/alarm.
  • No labels