Use the Flags window to configure redirecting capability flags in a Signaling Profile.

To View and Edit Flags

On the SBC main screen, choose a path:

  • Configuration > Profile Management > Category: Signaling Profiles > Signaling Profile > Egress > Redirection Capability Flags > Flags
  • All > Profiles > Signaling > Signaling Profile > Egress > Redirection Capability Flags > Flags

Select the Signaling Profile you want to configure from the drop-down list. The Flags window is displayed.

Note

This window displays parameters only when the Redirection Capability Flags option is enabled. 

Use the following table when configuring the options and then click Save.


Flags Parameters:

ParameterDescription
Check Carrier Code Combination

When enabled, the SBC matches the carrier code in the call against the configured carrier codes in the Carrier Code Combination Profile.

  • Disable (default)
  • Enable
Check Ingress Trunk Grp Redirection Capability

When enabled, the SBC checks for Ingress Trunk Group redirection capabilities.

  • Disable (default)
  • Enable
Check Number Control Profile For Received Called Number

 When enabled, the SBC checks the Number Control Profile for a match on the received called number.

  • Disable (default)
  • Enable
Check Received Redirection Params

 When enabled, the SBC checks for both the redirection capability and information parameters.

  • Disable (default)
  • Enable
Check Redirection Cap of Number Used for Routing In Number Control Profile

 When enabled, the SBC checks for redirection capabilities for the number used for routing.

  • Disable (default)
  • Enable
Check SIP Indirect Dip And Username Translation Source Number

 When enabled, the SBC checks whether the received request is a SIP Indirect DIP and whether it contains the Translation Source Number.

  • Disable (default)
  • Enable
Create Called Directory Number in Egress Signal On Redirection

When enabled, the original called party is sent by the SBC as the Called Directory Number.

  • Disable (default)
  • Enable
Skip Redirection On RACIndication Set

When enabled, if the Representative Area Code indicator is set to On in the JTI parameter, the SBC does not perform redirection.

  • Disable (default)
  • Enable

  • No labels