RAMP support only

Beginning with SBC Core release 12.0, the SBC interoperates with the Ribbon Application Management Platform (RAMP), replacing the Insight EMS.

However, the EMA, CLI and API will continue to include EMS-labeled parameters and screens to facilitate SBC migrations from older releases. Accordingly, any references to "EMS" in this documentation apply to the RAMP platform.

Overview

Use this section to configure EMA components using CLI.

To disable/enable EMA components from the CLI, the following enhancements are available:

  • The parameter ema is added under system admin. The child parameters of ema, each with the disable/enable options, are as follows:
    • enableCoreEMA
    • enableREST
    • enableTS
  • To display the status of the EMA components, the parameter ema, with its child parameters, are available under system admin of the show commands.

Command Syntax

To disable/enable the EMA components, use the following syntax:

% set system admin <system_name>
  ema
    enableCoreEMA <disabled | enabled>
    enableREST <disabled | enabled>
    enableTS <disabled | enabled>


To display the status of the EMA components, use the following syntax:

  • Within the "configure" mode:

    % show system admin <system_name> ema <enableCoreEMA | enableREST | enableTS>
  • Outside of the "configure" mode:

    > show table system admin <system_name> ema <enableCoreEMA | enableREST | enableTS>
Note

If you do not provide the name of the EMA component, the output displays the status of all the three components.

Command Parameters

Parameter Description Table

ParameterLength/RangeDescriptionM/O
emaN/AThe object encapsulating the three EMA components.O
enableCoreEMA
N/A

Use this parameter to disable or enable the Core EMA component.

  • disabled
  • enabled (default)
O
enableREST
N/A

Use this parameter to disable or enable the RESTCONF API services provided by the EMA for SBC configuration (using the SBC Manager of the RAMP).

  • disabled
  • enabled (default)
O
enableTS
N/A

Use this parameter to disable or enable the Troubleshooting component of the EMA.

  • disabled
  • enabled (default)
O

Configuration Examples

Tip

The SBC is enhanced to enable/disable these components independently; the state of one component does not affect the function of the other components. For using the full capabilities of the EMA, Ribbon recommends enabling all the components simultaneously.

You can disable/enable the components during installation, or after the installation. By default, all the components are enabled. For the post-installation changes to take effect, restart the application.


To configure the EMA components, use the following example:

% set system admin REDGRAPE-SA ema enableCoreEMA enabled enableREST disabled enableTS enabled


To display the status of the EMA components, use the following example:

  • Within "configure" mode:

    % show system admin REDGRAPE-SA ema
    enableREST    enabled;
    enableCoreEMA enabled;
    enableTS      enabled;
    [ok][<YYYY-MM-DD HH:MM:SS>]
  • Outside "configure" mode:

    > show table system admin REDGRAPE-SA ema
    enableREST    enabled;
    enableCoreEMA enabled;
    enableTS      enabled;
    [ok][<YYYY-MM-DD HH:MM:SS>]