In this section:

Related articles:


This section specifies the Redirect parameters for Egress Ip Attributes.

To View and Edit Redirect

On SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Ip Signaling Profile > Egress Ip Attributes > Redirect. The Redirect window is displayed.

DEFAULT_H323

On the Redirect window, choose the Ip Signaling Profile as DEFAULT_H323 to view the Redirect parameters for H323 Trunk Group.

Figure 1: Trunk Provisioning - Egress Ip Attributes H323 Redirect


There are no Redirect parameters for DEFAULT_H323 type of Egress Ip Attributes.

DEFAULT_SIP

On the Redirect window, choose the Ip Signaling Profile as DEFAULT_SIP to view the Redirect for SIP Trunk Group.

Figure 2: Trunk Provisioning - Egress Ip Attributes SIP Redirect


The following fields are displayed:

Table 1: Egress Ip Attributes SIP Redirect Parameters

Parameter

Description

Mode

Use this object to control SIP redirection:

  • Accept Redirection – (default) Multiple redirection are allowed.
  • Allow Single Redirect Attempt – Only a single Redirect is allowed per route. Additional Redirects cause crankback to be performed.
  • Reject Redirection – If a Redirect is received, crank back is performed.
Contact Handling

Select one of the following to control processing of contacts received in SIP Redirects:

  • Merge Received Contacts – Contacts received in Redirects are ordered by q-value and inserted at the head of the list of untried contacts.
  • Purge Existing Contacts – Contacts received in Redirects are ordered by q-value and replace untried contacts.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.


  • No labels