Use the Packet Outage window to set packet outage detection parameters for a specified SIP trunk group.

To View and Edit Packet Outage Parameters

On the SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Trunk Group > SIP Trunk Group > SIP Trunk Advanced > Packet Outage or
All > Address Context > Zone > SIP Trunk Group > Packet Outage

Use the drop-down boxes to select the specific Address Context, Zone and SIP Trunk Group you want to configure.

The Edit Packet Outage window is displayed.

Figure 1: SIP Trunk Group - Packet Outage Window

Use the following table to change the values as needed and then click Save.

Table 1: SIP Trunk Group - Packet Outage Parameters


Parameter


Description

Minimum DurationSpecify the minimum period of outage for a call, in milliseconds, for that call to be counted by the packet outage detection algorithm. Must be in the range 0-65535, default is 6000 (milliseconds).
Minimum CallsSpecify the minimum number of calls with outages in an interval to declare a packet outage event. Must be in the range 0-65535, default is 1000 (calls).
Bandwidth Limit ReductionSpecify the amount to reduce the bandwidth limit (as a percentage of the configured limit) when a packet outage is detected. Must be in the range 0-100, default is 50 (percent).

Detection State

Specify whether to enable automatic bandwidth reduction when a packet outage event is detected:

  • Disabled (default) – packet outages are not detected and the maximum bandwidth limit is not adjusted.
  • Enabled – automatic bandwidth reduction occurs when a packet outage is detected.

Detection Interval

Specify the length of time, in minutes, in which to count packet outages to compare against the Minimum Calls threshold before triggering a packet outage event. Must be in the range 5-1440, default is 15 (minutes).

Packet Outage Commands

To clear the packet outage detection state for a trunk group, select Clear in the Commands list and click Select.

Confirm that you want to clear the packet outage detection state when prompted.



 

 

  • No labels