In this section:


The Signaling Qos KPI Profile is associated with an IP Signaling Profile which in turn can be associated to an IP Peer or IP Signaling Peer Group or trunk group as a part of IP Signaling Profile.

To View Ip Signaling Peer Group

On SBC main screen, go to Configuration > System Provisioning > Category: Call Routing > Profiles > Ip Signaling Peer Group. The Ip Signaling Peer Group window is displayed.

Figure 1: Call Routing - Profiles - Ip Signaling Peer Group

To Edit Ip Signaling Peer Group

To edit any of the Ip Signaling Peer Group in the list, click the radio button next to the specific Ip Signaling Peer Group name.

The Edit Selected Ip Signaling Peer Group window is displayed below.

Figure 2: Call Routing - Profiles - Ip Signaling Peer Group Edit

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create Ip Signaling Peer Group

To create a new Ip Signaling Peer Group, click New Ip Signaling Peer Group tab on the Ip Signaling Peer Group List panel.

Figure 3: Call Routing - Profiles - Ip Signaling Peer Group Fields

The Create New Ip Signaling Peer Group window is displayed.

Figure 4: Call Routing - Profiles - Ip Signaling Peer Group Create Window

The following fields are displayed:

Table 1: IP Signaling Peer Group

Parameter

Description

Name

Specifies the name of the IP Signaling Peer Group.

Description

Specifies a short description of the IP Signaling Peer Group used.

Send All Ip Address And FQDN

Specifies whether to send all the IP Addresses and the FQDNs using this IP Signaling Peer Group or not.

The options are:

  • disable
  • enable
IP Signaling Peer Group Data

Sequence

Specifies the sequence of this IP Signaling Peer Group.

Service Status

Specifies the type of service for this IP Signaling Peer Group. Select inService to use this IP peer.

The options are:

  • inService
  • outOfService

Ip Address

Specifies the IP Address of this IP Signaling Peer Group.

Ip Port

Specifies the TCP/UDP port value of this IP Signaling Peer Group.

Fqdn

Specifies the FQDN value to use for sending egress calls/requests to the IP peer.

Fqdn Port

Specifies the FQDN port number to be used for sending egress calls/requests to the  IP peer.

To Delete Ip Signaling Peer Group

To delete any of the created Ip Signaling Peer Group, click the radio button next to the specific IP Signaling Peer Group which you want to delete.

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Click Yes to remove the specific Ip Signaling Peer Group from the list.


  • No labels