Use the DSP Call Interval Statistics window to view system DSP resource statistics, in terms of calls, for a series of statistics intervals. To set the statistics time interval and the number of intervals to report, refer to System - Interval Statistics.
On the SBC main screen, go to Monitoring > System > Category: System Status and Statistics > DSP Res > DSP Call Interval Statistics or
All > System > DSP Res > DSP Call Interval Statistics
The DSP Call Interval Statistics window is displayed.
Figure 1: DSP Call Interval Statistics
The following output is displayed:
Table 1: DSP Call Interval Statistics
Parameter | Description |
---|---|
Number | Specifies a sequence number which identifies the interval for which the set of statistics is shown. |
System Name | The node name. |
Interval Valid | A setting of 'true' indicates the interval contains valid data during the time interval. Each interval is for a configurable fixed time (default interval is 15 minutes) starting on the hour. For example, if the system starts at 12:05, the first interval at 12:15 will not be valid because it is less than the 15-minute interval. Subsequent intervals will be valid upon meeting the 15-minute time interval. System switch-overs also cause invalid intervals because data is lost during the interval.
|
Time | System up time when the interval statistics were collected. |
Num Call Success No DSP Alloc Failure | Number of successful calls without DSP resource allocation failure for the specified statistics interval. |
Num Call Success With DSP Alloc Failure | Number of successful calls with DSP resource allocation failure for the specified statistics interval. |
The table contains three columns for each codec:
The following codecs appear:
|
Overview
Content Tools