The following procedure describes how to use the Windows PC/terminal to connect to the SBC 7000 serial port and assign the BMC an IP address.

Procedure

  1. Connect one end of the supplied serial cable (DSUB 9-Pin Female to DSUB 9-Pin Male) to the SBC DB9 serial port and the other end to the serial port of your PC.

  2. Use the following serial port settings of PC.
    Baud:115200
    Data bits:8
    Stop bits:1
    Parity:None
    Flow Control:None

  3. Login to the BMC using default credentials:
    At the prompt enter:
    Username: linuxadmin
    Password: <password>

  4. Switch User to 'root' using the command: su -
    Enter the 'root' access password.

  5. Execute the bmcInit.sh command. Assign the BMC management IP address, netmask, default gateway and NTP time server IP address.

    Example:
# sh bmcInit.sh
*************************************************************
***                BMC Initialization                     ***
*************************************************************
Enter BMC management IP (aaa.bbb.ccc.ddd)     : 10.2.12.181
Enter BMC management netmask (aaa.bbb.ccc.ddd): 255.255.255.0
Enter default gateway IP (aaa.bbb.ccc.ddd)    : 10.2.12.1
Enter NTP time server IP (aaa.bbb.ccc.ddd)    : 10.1.1.2

Enter advanced configuration? <y/n>:n

Note: The advanced configuration is used exclusively to configure static routes. For this installation example, enter "n".

Verify your entries....
bmcIpAddr       = 10.2.12.181
bmcNetmask      = 255.255.255.0
gatewayIpaddr   = 10.2.12.1
ntpServerIpaddr = 10.1.1.2

Ok to apply configuration? <y/N>:y

Restarting NTP and network services ....
Setting up IP spoofing protection: rp_filter.
Reconfiguratoin network interfaces...done.
Restarting NTP server: ntpd... done.
Note: Reboot the BMC after completing the process.
  6. Connect the Field Service port of SBC to the Ethernet router to access the BMC over the network.

Continue to Configuring SBC 7000 BMC for Remote Access.

  • No labels