Note
Applicable only for CALEA users
Overview
This section briefly describes the commands for configuring LI on S-SBC.
Note
- As a prerequisite to configure LI (any supported variety) on S-SBC, ensure that the Call Data Channel (CDC) and the Mediation Server are enabled and running.
- You can configure LI using default address context only.
- For more information on the parameters (descriptions and supported values), refer to Intercept - CLI.
Configure Default LI on S-SBC
% set addressContext default intercept callDataChannel <CDC Name> interceptStandard <Default LI supported Value> vendorId <Default LI Supported Values> ipInterfaceGroupName <LIG1 from where data is sent> priIpAddress <IPv4 address> priPort <port> priState <disbled | enabled> priMode <active | outofservice | standby> % commit
Tip
In the above example, you can also configure secondary IP address, by including the following parameters:
secIpAddress <IP_Address>
secMode <active | outofservice | standby>
secState <disabled | enabled>
Note
For Default/Legacy LI on the M-SBC, ensure that the LIF group name used to send the X3 intercepted data is the same as the interface name in the S-SBC (used to send the X2 data on the S-SBC).
Configure IMS LI on S-SBC
To provision IMS LI on S-SBC, configure the Signaling (X2) interface using the two commands shown below:
Tip
Perform a commit after each step.
% set addressContext default intercept callDataChannel <CDC Name> interceptStandard <IMS LI supported Value> vendorId <IMS LI Supported Values> ipInterfaceGroupName <LIF Group information> % set addressContext default intercept callDataChannel <CDC Name> mediationServer <mediation server name> signaling ipAddress <ip address of mediation server> portNumber <port number of mediation server> protocolType <tcp | udp>
Configure PSCI LI on S-SBC
% set addressContext default intercept callDataChannel <CDC Name> interceptStandard <IMS LI supported Value> vendorId <IMS LI Supported Values> % commit
Overview
Content Tools