Ribbon provides replacement units to the Customer, and the Customer performs the installation for these replacement units. For CRU information and replacement instructions, refer SBC 7000 CRUs.
SBC 7000 Platform CRUs
Equipment Requirement | Description |
|---|---|
Fan Assembly | Four dual cooling fan assemblies located behind the front bezel. |
Solid State Drives | The 800GB or 960GB Solid State Disk (SSD) storage located behind the front bezel. Push the button beside disk to power down before removing the SSD drive. |
Air Filter | Located within the front bezel assembly, filters the cooling air. |
Front Bezel | Secures replaceable air filter to front of chassis and identifies LED status indicators. |
SFPs (Small Form-Factor) Plugs | Supports Single and Multi-mode Fiber SFPs and Copper SFPs (which functions like a plug) used for Gigabit Ethernet connections to Media ports and HA ports. The SFPs for media ports must be 10 Gigabit. Connect to LC-connector on the SFP side and SX-module on the other end of the connection to L3 switch. |
| DSP Modules | The top 4 slots (1-4) of the rear panel are used for optional specialized hardware modules, the first released module being the DSP-LC high capacity transcoding resource module. |
| CSC7000 (Core Server Card) | Located at slot 0 (above SCC slot) of the rear panel. It is used for used for Control and Data plane processing. |
| SCC7000 (System Controller Card) | Located at SCC slot (bottom right) of the rear panel. It is used for chassis management and Processing (also known as BMC Baseboard Management Controller). |
Power Supply | Up to two DC or two AC power supply modules accessible from the rear of the chassis, and located on the bottom row next to SSC slot. NOTE: Changing the power supply module voltage type (AC to DC, or DC to AC) is not supported on the SBC 7000 platform. |
Info
Refer to SBC 7000 Customer Replaceable Units for CRU component replacement details.
The ESD Susceptibility symbol 
warns of the presence of Ribbon devices susceptible to electrostatic discharge. Do not handle equipment without wearing a properly grounded ESD wrist strap.
Overview
Content Tools