In this section:
This section provides information on the SBC 5400 package content and required tools to rack mount the SBC platform.
Required Tools
Before you install the SBC 5400 chassis into a rack, make sure that you have the following tools and equipment:
- #2 Phillips screwdriver (to install brackets and the chassis)
- 7/16" (11 mm) wrench (to attach earth ground lug)
- Label maker (to label cables, if needed)
- Voltmeter (for installing units with DC power supplies)
- A marker or masking tape to mark mounting holes
SBC 5400 Package Content
Before you install a new SBC 5400 chassis, unpack and inspect your equipment and hardware to verify that you have all the necessary items to install your SBC 5400 chassis.
Accessory Kit
The following table provides the list of Bill of Materials (BOMs) provided with the SBC 5400 Accessory Kit.
Carefully remove the contents from the shipping container, and check each item for damage. The SBC 5400 is shipped with the items listed below. If any item is missing or damaged, contact your Ribbon representative for support.
Universal Rack Mount Kit
The following items are included in each Universal Rack Mount Kit:
Item | Quantity |
---|---|
Chassis Rail | 2 |
Rack Rail Guide | 2 |
Chassis Rack Ear | 2 |
19" to 23" Rack Adaptor | 4 |
Rack Mount Bracket | 4 |
#8-32X1/4" Truss Head screw | 24 |
#10-32X5/16" Flat Head screw | 4 |
#10-32-5/8" Cup Head screw | 20 |
#10-32 U-Nut | 12 |
The following figure describes the Universal Rack Mount Kit contents.