In this section:
Use this parameter to configure a user password policy for Administrator users which is different than Conf-D users.
You must set pathCheckProfile parameter protocol
to "icmp
" to use this feature. Refer to Path Check Profile - CLI for configuration details.
Command Syntax
% set system pathCheckPath <Path Check Path name> addressContext <addressContext name> ipInterface <IP Interface name> ipInterfaceGroup <IPIG name> pathCheckProfile <Patch Check Profile name> reportSignalIpAddress <IPv4/IPv6 address> reportSignalIpPort <Port Id> sourceIpAddress <IPv4/IPv6 address> state <disabled | enabled> targetIpAddress <IPv4/IPv6 address> zone <Zone name>
Command Parameters
Parameter | Length/Range | Description |
---|---|---|
<pathCheckPath name> | 1-23 | The Path Check Path name |
| N/A | Address Context where the corresponding Interface Group is present |
| N/A | IP interface from which ping is generated |
| N/A | IP Interface Group where the corresponding IP Interface is present |
| N/A | Path Check profile name used when pinging this peer |
| IPv4/IPv6 format | Reported Signaling IP address of the ping path |
| 0-65535 | Reported Signaling Port of the ping path |
| IPv4/IPv6 format | Source IP address of the ping path |
| N/A | Defines if active pinging is enabled or disabled
Note
Set the state to |
| IPv4/IPv6 format | Target IP address of the ping path |
| N/A | Zone name used when pinging this peer |