DO NOT SHARE THESE DOCS WITH CUSTOMERS!
This is an LA release that will only be provided to a select number of PLM-sanctioned customers (PDFs only). Contact PLM for details.
In this section:
The staticRoute
object is used to configure static IP routes for the IP interfaces. A static route indicates the nextHop gateway and IP interface that is used for a particular peer network IP prefix.
A route preference
may be configured for static routes as shown in the command syntax. The lower the preference value, the more likely the route is to be used.
ceName
separately.staticRoute
with respect to a ceName
cannot be edited. If any change is desired in the configuration, delete the staticRoute
and reconfigure it.
The SBC 5210 and SBC 7000 systems support creating IP Interface Groups containing sets of IP interfaces that are not "processor friendly" (i.e. carried on physical Ethernet ports served by separate processors). However, restrictions exist regarding the usage of such Interface Groups.
(This ability does not apply to the SBC 5110 and 5400 systems which have only two physical media ports. IP interfaces from the two physical ports may be configured within the same IP Interface Groups without restrictions.)
For complete details, refer to Configuring IP Interface Groups and Interfaces.
% set addressContext <addressContext_name> staticRoute <destinationIpAddress> <ip_prefix_length> <nextHopIPaddress> <ipInterfaceGroupName> <ipInterfaceName> condition ceName (node name) preference <100-2147483647> % show addressContext <addressContext_name> staticRoute % delete addressContext <addressContext> staticRoute <IpAddress>
Static Route Parameters
Parameter | Length/Range | Description |
---|---|---|
| 1-23 |
|
| N/A |
|
| 0-128 | The IP prefix length of this static route entry. |
| N/A | The IPv4 or IPv6 address of the next system en route to the destination. |
| N/A | The name of the IP interface group. |
| N/A | The name of the IP interface for this entry. |
condition | N/A | For an SBC HA pair configuration (only), use this object to define the routes added to this SBC HA pair.
NOTE: The SBC supports only the NOTE: Before configuring the NOTE: The |
| 100-2147483647 |
|
To display static routes:
% show addressContext default staticRoute staticRoute 10.6.30.105 32 10.34.26.1 LIF2 lif_eth3 { preference 10; } staticRoute 10.34.9.70 32 10.34.25.1 LIF1 lif_eth2 { preference 10; } staticRoute 10.34.9.95 32 10.34.26.1 LIF2 lif_eth3 { preference 10; } staticRoute 10.34.13.194 32 10.34.25.1 LIF1 lif_eth2 { preference 1; } staticRoute 10.34.13.195 32 10.34.26.1 LIF2 lif_eth3 { preference 10;
The staticRoute
object is used to configure static IP routes for the management interfaces. A static route indicates the nextHop gateway and management interface that is used for a particular peer network IP prefix.