DO NOT SHARE THESE DOCS WITH CUSTOMERS!

This is an LA release that will only be provided to a select number of PLM-sanctioned customers (PDFs only). Contact PLM for details.

 

Use the following steps to mount SBC 7000 chassis in a 23 inch 2-post rack.

Due to the size and weight of the SBC 7000 chassis, at least two people are required when lifting, mounting or unmounting the chassis.

 


 

  1. Gather the fixed mount brackets from the rack kit.
  2. Optional step: Using the fixed mount front brackets, locate the holes for your two top rack mounting screws (one for each bracket), whichever size is appropriate. Ensure there is at least 2.25" clearance above and 1.5" below bracket location. Also, ensure four rack holes are visible through the four obrounds in the bracket.  Install top location rack mount screws only, finger tight, then back screws out one full rotation to allow the bracket to slide freely between the screws and the rack.

     

    Setting 19 2-Post Rack Mount

  3. Using six of the supplied #10-32X5/16” flathead Philips screws (three screws per bracket), secure the front fixed mount brackets to the sides of the system.

    Attaching Mount Brackets to the system

  4. Lift the system to the desired location in the rack.  If top location rack screws have been installed, align top clearance hole in the front mount rack bracket over screw head and install fully flush with rack, sliding screw into obround relief in the bracket.
  5. Using four screws per side, secure the fixed mount front brackets attached to the system to the front of the rack. The size of the screw varies, depending on your particular rack.

    Completing Rack Mounting

 

 

  • No labels