In this Section:

 

Overview

The Call Detail Status displays the ingress and egress characteristics of the call.

  • Circuit-to-Circuit calls display DSP information such as echo canceller settings, signal energy levels, and audio type values on both sides of the call.
  • Circuit-to-Packet calls display the DSP information for the circuit side of the call and the packet side parameters such as the configured audio codec from the Packet Service Profile, the actual audio codec currently in use for the call, and other IP parameters, including information on IP Loopback for IXP IP looped legs. The actual codec may differ from the configured codec if the SBC software detects FAX or modems and thus switches from a compression codec to G.711 or T.38.
  • Packet-to-packet calls contains a set of RTP statistics for both their ingress and egress legs.

Viewing Call Detail Status

On the navigation pane:

Click Global > CAC > Call Detail Status. The Call Detail Status window is displayed.

Call Detail Status

Note

When call volumes are high, EMA takes approximately 30 seconds to display the output.

Parameter Descriptions

For parameter descriptions, refer to the Call Detail Status section in Show Table Global page.

  • No labels