IMPORTANT

The SBC 5110 and SBC 5210 hardware platforms are no longer supported beginning with the 10.0.0R0 release. This release supports SBC 5400/7000/SWe platforms. Contact Ribbon Sales for upgrade information.

Use this window to configure egress call admission control (CAC) parameters for a specified zone.

On the SBC main screen, go to Configuration > System Provisioning > Category: CAC Provisioning > Zone > CAC > Egress or
All > Address Context > Zone > CAC > Egress

 Use the drop-down lists to select an Address Context and Zone to configure.

Zone CAC - Egress Window

 

Note

SIP subscription CAC limits are not applied to SUBSCRIBE requests from registered users in access deployments.

Use the following table to configure the parameters and then click Save.

Zone - CAC - Egress Parameters


Parameter


Description

Call LimitSpecifies the total number of calls allowed for egress.
Emergency OversubscriptionSpecifies the oversubscription of resources (as a percentage) that is allowed for emergency calls. The value ranges from 0 to 1000 and the default value is 10.
Extended Emergency IP LimitThe resource oversubscription (expressed as numeric value) allowed for emergency calls. The value ranges from 0 to 40000 with a default value of 0.
Call Rate Max

Specifies the value of maximum allowed sustained egress rate (in calls/second) for egress call attempts.

SBC 5400 / SWe - Range: 1-450, or unlimited. (The default value is unlimited.)

SBC 7000 - Range: 1-1,350, or unlimited. (The default value is unlimited.)

Note: You can set both Call Burst Max and Call Rate Max as unlimited; however, if you assign a value to one parameter, the other must also be assigned a value.

Call Burst Max

Specifies the value of maximum allowed burst (above the allowed sustained rate) for egress call attempts in calls/second. 

SBC 5400 /SWe - Range: 1-900, or unlimited. (The default value is unlimited.)

SBC 7000 - Range: 1-2,700, or unlimited. (The default value is unlimited.)

Note: You can set both Call Burst Max and Call Rate Max as unlimited; however, if you assign a value to one parameter, the other must also be assigned a value.

Register Rate MaxSpecifies the maximum allowed sustained egress rate (registrations per second) for initial SIP registrations. (1-1500, or unlimited for SBC 5400; 1-3000, or unlimited for SBC 7000 series). The default value is unlimited.
Register Burst MaxSpecifies the maximum allowed egress burst (above the allowed sustained rate) for initial SIP registrations. (1-1500, or unlimited for SBC 5400; 1-3000, or unlimited for SBC 7000 series). The default value is unlimited. 
Hpc OversubscriptionSpecifies the over-subscription of the resources (in a percentage) that is allowed for HPC calls. When the baseline call limit and bandwidth limits are reached, normal calls are not admitted, but additional HPC calls are allowed up to the configured value percentage. The value ranges from 0 to 100 % and the default value is 10 %.

  • No labels