In this section:
Ribbon recommends using the Transparency Profile to configure transparency on the SBC Core for new deployments, as well as applying additional transparency configurations to existing deployments. Do not use IP Signaling Profile flags in these scenarios because the flags will be retired in upcoming releases.
Refer to the SBC SIP Transparency Implementation Guide for additional information.
Specifies the name of SIP header to transparently pass.
The flexible header transparency profile supported in earlier release, where transparency for a random header is achieved by adding its name to the profile. The functionality was limited to initial INVITE request, REGISTER request, and mid-dialog requests in an INVITE initiated dialog (excluding a mid-dialog SUBSCRIBE as it is not supported). Selective unknown headers can be passed transparently in REGISTER, initial INVITE, and in mid-dialog requests in an INVITE initiated dialog. Header transparency was not supported for out-of-dialog messages in earlier SBC release.
The SBC supports the following out-of-dialog functionality:
On SBC main screen, go to Configuration > Profile Management > Category: Service Profiles > Transparency Profile > Sip Header.
Select the desired Transparency Profile from the drop-down list to view/edit the Sip Header parameters.
The Sip Header window is displayed.
To edit any of the Sip Header in the list, click the radio button next to the specific Sip Header name.
The Edit Selected Sip Header window is displayed below.
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
To create a new Sip Header, click New Sip Header tab on the Sip Header List panel.
The Create New Sip Header window is displayed.
The following fields are displayed:
If a specific header is configured, Ignore Transparency
and Excluded Methods
are exclusive. If Ignore Transparency
is configured, Excluded Methods
is not displayed later. If Excluded Methods
is configured, Ignore Transparency
is not displayed.
The Ignore Transparency
configurable applies in the following cases:
To copy any of the created Sip Header and to make any minor changes, click the radio button next to the specific Sip Header to highlight the row.
Click Copy Sip Header tab on the Sip Header List panel.
The Copy Selected Sip Header window is displayed along with the field details which can be edited.
Make the required changes to the required fields and click Save to save the changes. The copied Sip Header is displayed at the bottom of the original Sip Header in the Sip Header List panel.
To delete any of the created Sip Header, click the radio button next to the specific Sip Header which you want to delete.
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
Click Yes to remove the specific Sip Header from the list.