In this section:
Ribbon recommends using the Transparency Profile to configure transparency on the SBC Core for new deployments, as well as applying additional transparency configurations to existing deployments. Do not use IP Signaling Profile flags in these scenarios because the flags will be retired in upcoming releases.
Refer to the SBC SIP Transparency Implementation Guide for additional information.
This section specifies the Privacy parameters for Egress Ip Attributes.
On SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Ip Signaling Profile > Egress Ip Attributes > Privacy. The Privacy window is displayed.
On the Privacy window, choose the Ip Signaling Profile as DEFAULT_H323 to view the Privacy parameters for H323 Trunk Group.
There are no Privacy parameters for DEFAULT_H323 type of Egress Ip Attributes.
On the Privacy window, choose the Ip Signaling Profile as DEFAULT_SIP to view the Privacy parameters for SIP Trunk Group.
The following fields are displayed:
Parameter | Description |
---|---|
Transparency | Enable flag to allow ingress Privacy information to pass through unchanged.
|
Privacy Information | NOTE: This parameter is visible only when the Use this object to specify which of the following headers the SBC uses when sending privacy information in outgoing SIP INVITE messages:
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
When the Transparency
flag is set to Enable
. The appearance of the Edit Privacy window changes, and the Anonymize Host IP Portion
flag appears.
By default, the flags Transparency
and Anonymize Host IP Address
are set to Disable
for the Egress IP Attributes of all IP Signaling Profiles.
The flag Anonymize Host IP Portion
is described in the table below:
Parameter | Description |
---|---|
Anonymize Host IP Portion | When the flag is set to To activate this feature, set the flag
|
To enhance privacy transparency, set the Anonymize Host IP Portion
flag to Enable
.
To save the changes, click Save. To cancel all changes made since the last saved state, click Undo Edits.