The LAN interface ports are pre-configured with the IP address 192.168.1.250.

Warning

If the device is using firmware 16.2.0 or later, the EdgeMarc 300 will attempt to obtain an IP address via DHCP.


Caution

 Please make sure that nothing besides your PC is connected to the LAN ports of the EdgeMarc 300.

  1. Connect LAN Port 4 to a PC using an Ethernet cable. Alternatively connect a LAN port on the EdgeMarc to an Ethernet switch.
  2. If the Edgemarc has not been connected to the LAN, give the PC the IP address of 192.168.1.2 and subnet mask 255.255.255.0. If the Edgemarc has been connected to the local LAN, the IP address on the Edgemarc will be an IP address derived from the DHCP pool serving local devices at the site. This may require that the PC be given IP address appropriate to the local LAN network.
  3. Launch a web browser on your computer and enter the URL http://192.168.1.250 or the DHCP-assigned address.

  4. Press Return. The EdgeMarc login screen is displayed. 

    EdgeMarc login screen

  5. Enter your initial username in the field provided: root

  6. Enter your initial password in the field provided: default

  7. Click OK.

  8. After you have logged in to the system for the first time with the default credentials, you are directed to the Change Password page.

    Change password page

  9. Enter your Current and New Passwords in the Change Password Page according to the new password instructions given on the page and then click Change Password. The Password Change Confirmation Page is displayed. 

  10. Select Click here to log on with your new password from the Password Change Confirmation Page. 

  11. You are directed to the EdgeMarc login screen again. Log in to the EdgeMarc Admin landing page (see below figure) with your User Name and New Password from the EdgeMarc login screen.

    EdgeMarc Admin landing page