In this section:

This page allows you to map Q.850 (ISDN) Cause Code to SIP Response and vice versa.

Note

Cause Mapping is unavailable on EdgeMarc 6000-8S, EdgeMarc 2900 Series, EdgeMarc 7000 Series, and EdgeMarc 300 Series devices.

ISDN-SIP

This page allows you to set an SIP Error Response value for each Q.850 Cause Code received.

The Q.850/ISDN Cause to SIP Response Mapping page can be modified without causing any service disruption. When modified, the saved changes will take effect on the next SIP -> ISDN call that receives a disconnect before completing the call. You cannot make any changes when pending configuration changes are present.

When performing an edit, you can modify any number of values during a single edit operation.

The page is configured to be a table with 3 columns:

  • Q.850 Cause Code - This column is a list of each defined Q.850 cause code.
  • Default SIP Response Code - This column lists the default SIP Error Response sent for each Q.850 cause code received.
  • SIP Response - This is a list of all possible SIP Error Response codes supported. The field is usually disabled and can only be changed when performing an edit for the page.

Q.850/ISDN Cause to SIP Response Mapping

To edit the Q.850/ISDN Cause to SIP Response Mapping:

  1. Choose Network > ISDN > Cause Mapping > ISDN-SIP.


  2. Scroll to the bottom of the page and click Edit.
    All the fields under SIP Response now become active.
  3. Configure the SIP Response values as required.
  4. Click Submit to save your changes.

SIP-ISDN

This page allows you to set a Q.850 Cause Code value for each SIP Error Response Code received.

The SIP Response to Q.850/ISDN Cause Mapping page can be modified without causing any service disruption. When modified, the saved changes will take effect on the next ISDN -> SIP call that receives a SIP Error Response before completing the call. This page does not allow any changes when pending configuration changes are present. 

When performing an edit, you can modify any number of values during a single edit operation.

The page is configured to be a table with 3 columns.

  • SIP Response - This column is a list of each defined SIP Error Response.
    • Default Cause Code - This column lists the default Q.850 Cause Code that will be sent for each SIP Error Response received.
    • Cause Code - This is a list of all possible Q.850 Cause Codes supported. The field is usually disabled and can only be changed when performing an edit for the page.

SIP Response to Q.850/ISDN Cause Mapping

To edit the SIP Response to Q.850/ISDN Cause Mapping:

  1. Choose Network > ISDN > Cause Mapping > SIP-ISDN.

  2. Scroll to the bottom of the page and click Edit.
    All the fields under Cause Code now become active.
  3. Configure the Cause Code values as required.
  4. Click Submit to save your changes.