You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 3
Next »
The
Unable to show "metadata-from": No such page "_space_variables"
supports setting the media (including codec) policy on a call-by-call basis. Media parameters are defined in the Packet Service Profile (PSP) which can be attached to an IP trunk group or IP Peer. For each call, an ingress PSP and an egress PSP is determined, and then these PSPs are “combined” to arrive at a set of media parameters for the call.
The PSP includes the following configurable features:
- allowed codecs (ordered list)
- packetization parameters
- fax handling
- modem handling
- DTMF handling
- transcoding combinations
The Packet Service Profile supports up to four audio codecs using ERE. Compression algorithms available for assignment to these are shown below.
The PSX supports configuring up to 12 codecs in the Packet Service Profile and Preferred Packet Service Profile. The
Unable to show "metadata-from": No such page "_space_variables"
supports receiving all 12 codecs from the PSX in the PSP and Preferred PSP. This applies to interworking with an external PSX (Advanced ERE deployment scenario). See
Routing and Policy Management for deployment scenario details.
Additionally, the
Unable to show "metadata-from": No such page "_space_variables"
supports up to 12 codecs over Gateway links to SBCs and/or GSXs.
An SBC-POL-RTU license is needed to enable more than four codecs.
When call endpoints do not share a common codec, or to preserve different packet sizes, silence suppression and/or DTMF relay methods on each call leg, the
Unable to show "metadata-from": No such page "_space_variables"
performs media translations (transcodings) necessary for the endpoints to connect.
Transcoding between any two supported compressed audios requires two DSP channels. Two channels each transcoding between G.711 (or IDP) and one compression codec are bound together in tandem to support a compressed-to-compressed transcoding. SBC defines which audio and video codec pairs to transcode. See Audio Codecs and Video Codecs pages.
Additional topics in this section: