This procedure is not applicable to the
The Ribbon Application Management Platform can launch an This feature for the With the Ribbon Application Management Platform enabled, the If a timeout results in the runtime status not being retrieved, then the To enable the Ribbon Application Management Platform, you must configure the Ribbon Application Management Platform panel (see the following procedure) according to your When you enter the Management ID, you must insert a colon every two characters (00:00:00). Otherwise, the Requirements
For intermittent connectivity failure from the
Configure the Unable to show "metadata-from": No such page "_space_variables" for Ribbon Application Management Platform during Initial Setup
To configure the
- Unable to show "metadata-from": No such page "_space_variables"- Running Initial Setup
- Unable to show "metadata-from": No such page "_space_variables"- Running Initial Setup on SBC SWe Edge
When you configure the Initial Ribbon Setup screen, use the following table to configure the Ribbon Application Management Platform panel.
When you enter the Management ID, you must insert a colon every two characters (00:00:00). Otherwise, the
Troubleshooting Tips - Intermittent Connectivity from
- Wait at lease 2 -3 minutes minutes before determining connection is down; it may not be instantaneous.
- Examine the rbbnramp logs and the response to the registration request the SBC transmits to Ribbon Application Management Platform. Ribbon testing experienced that when the SBC does not connect to Ribbon Application Management Platform, there is usually an error response from Ribbon Application Management Platform, and the problem is on the Ribbon Application Management Platform side.
- For a failed response from the Ribbon Application Management Platform the retry to connect to Ribbon Application Management Platform is not instantaneous. There is an increasing delay with each retry, and eventually only trying with a very long time out. This increase in delay is by design; when an Ribbon Application Management Platform goes down or has connectivity problems, all the devices trying to connect to it will not flood it at the same time with too many requests.
Options to Reconnect
Two options to recover/re-establish connection:
- Reboot Unable to show "metadata-from": No such page "_space_variables"(not required)
- Toggle Ribbon Application Management Platform connection (execute the steps listed in Configure the SBC Edge for Ribbon Application Management Platform during Initial Setup