In this section:
This object is used to configure IPsec SPD for the SBC. The SPD establishes the phase 2 criteria for negotiation between the SBC and the IKE peer. The successful completion of this negotiation results in a Security Association (SA).
On SBC main screen, navigate to All > Address Context > Ipsec > SPD.
The SPD can be checked for each Address Context or for all the Address Contexts created. Use the drop-down box to select the desired Address Context.
The SPD window is displayed.
To edit any of the SPD in the list, click the radio button next to the specific SPD name.
The Edit Selected SPD window is displayed below.
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
To create a new SPD, click New SPD tab on the SPD List panel.
The Create New SPD window is displayed.
The following fields are displayed:
Parameter | Length/Range | Description |
---|---|---|
| 1-23 | Specifies the name of an IPsec Security Policy Database (SPD) entry. The IPsec SPD is an ordered list of entries ("rules") that specify sets of packets and determine whether or not to permit, deny, or protect packets between the SBC and the peer that is referenced from the entry. If the packets are to be protected, this entry references information that specifies how to protect them. You may create and configure up to 4,096 SPD entries. |
State | NA | Administrative state to disable or enable a SPD entry. |
Precedence | 0-65535 | A unique precedence (evaluation order) for this SPD. |
Local Ip Addr | N/A | Specifies the local IPv4 or IPv6 address of the SPD traffic selector. Zero indicates wildcard. |
Local Ip Prefix Len | 0-128 | Specifies the local IP prefix length of the SPD traffic selector. Default value is 0. |
Local Port | 0-65535 | Specifies the local port of the SPD traffic selector. Zero indicates wildcard. Default value is 0. |
Remote Ip Addr | NA | Specifies the remote IPv4 or IPv6 address of the SPD traffic selector. Zero indicates wildcard. |
Remote Ip Prefix Len | 0-128 | Specifies the remote IP prefix length of the SPD traffic selector. Default value is 0. |
Remote Port | 0-65535 | Specifies the remote port of the SPD traffic selector. Zero indicates wildcard. Default value is 0. |
Protocol | 0-255 | Specifies the IP protocol number of the SPD traffic selector. This parameter uses IANA protocol number assignment, that is, protocol number 6 represents TCP, protocol number 17 represents UDP. Zero indicates wildcard. Default value is 0. |
| N/A | Action applied when packets processed by IPSEC found matching the selectors of this SPD rule.
|
| NA | This parameter is only applicable if the Use this parameter to set the IPsec mode for the SPD.
|
To copy any of the created SPD and to make any minor changes, click the radio button next to the specific SPD to highlight the row.
Click Copy SPD tab on the SPD List panel.
The Copy Selected SPD window is displayed along with the field details which can be edited.
Make the required changes to the required fields and click Save to save the changes. The copied SPD is displayed at the bottom of the original SPD in the SPD List panel.
To delete any of the created SPD, click the radio button next to the specific SPD which you want to delete.
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
Click Yes to remove the specific SPD from the list.