This object is visible only for distributed SBC (D-SBC) deployments.
Use this the Dsbc Sig Port window to configure the D-SBC signaling ports for the IP Interface Group used to communicate between the signaling, media, and transcoding SBCs in a deployment.
You must configure Cluster Admin for intra-cluster node communication before configuring a D-SBC signaling port, Load balancing service and DNS group parameters.
From the SBC main screen, go to All > System > Dsbc > Dsbc Sig Port.
The Dsbc Sig Port window opens.
Figure 1: Dsbc Sig Port Window
Make sure when configuring SIP signaling ports and D-SBC signaling ports for an S-SBC deployment that you specify different IP addresses for them. To do so you must select different metavariables for each of them. The actual values of the metavariables are determined during orchestration of your deployment.
Use the following table to configure the parameters and then click Save.
Parameter | Description |
---|---|
Type | The interface type supported by the D-SBC.
|
IP Interface Group | The name of the IP Interface Group to use for D-SBC communication. |
Address Context | The name of the address context containing the D-SBC IP Interface Group. |
IP Var V4 | The name of the configuration variable to get the IPv4 address for this D-SBC signaling port. |
IP Public Var V4 | The name of the configuration variable to get the public/floating IPv4 address for this DSBC signaling port. |
IP Var V6 | The name of the configuration variable to get the IPv6 address for this D-SBC signaling port. |
IP Public Var V6 | The name of the configuration variable to get the public/floating IPv6 address for this DSBC signaling port. |
Transport Type | The transport type to use for the D-SBC signaling link. |
Encryption Type | The encryption type used in the D-SBC signaling link.
|
Mode | The D-SBC signaling port mode.
|
State | The state of the D-SBC signaling listener port.
|