You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Next »

In this section:

 

Use this feature to configure specific SIP response codes to particular internal SIP request rejections from SIP Service Group.

Command Syntax

% set profiles signaling sipCauseCodeMapping internalSipCauseMapProfile <profile_name> causeMap 
	congestionPolicing sipCause <300-606> 
	otherReqRatePolicing sipCause <300-606> 
	regRatePolicing sipCause <300-606> 
	regTGLimit sipCause <300-606> 
	regTimeout sipCause <300-606> 
	subsEndPointRatePolicing sipCause <300-606>
	subsRatePolicing sipCause <300-606> 
	subsTGLimit sipCause <300-606>

Use following CLI syntax to attach an Internal SIP Cause Map profile to a SIP trunk group.

% set addressContext <addressContext_name> zone <zone_name> sipTrunkGroup <TG_NAME) signaling causeCodeMapping sipInternalCauseMappingProfile <profile_name> 

Command Parameters

The Internal SIP Cause Mapping Profile Parameters are shown below:

SIP Cause Mapping Profile Parameters

 

Parameter

Length/Range

Description

internalSipCauseMapProfile

1-23

<profile name> – Internal SIP Cause Map Profile name.

causeMap

N/A

Use this object to configure custom SIP cause response codes.

  • congestionPolicing sipCause <value> – SIP cause code used when an initial SUBSCRIBE request is rejected due to Adaptive Overload Control. This internal cause code is mapped to 503 by default, and a Retry-After header is added to it. The Retry-After value is randomized between 'retryAfterMin' and 'retryAfterMax' values.
  • otherReqRatePolicing sipCause <value> – SIP cause code when a message rate other than REGISTER or SUBSCRIBE exceeds IP trunk group's maximum configured value.
  • regRatePolicing sipCause <value> – SIP cause code when REGISTER message rate exceeds IP trunk group's maximum configured value.
  • regTGLimit sipCause <value> – SIP cause code when current REGISTRATION exceeds IP trunk group's maximum registration limit.
  • regTimeout sipCause <value> – SIP cause code from REGISTER request timeout.
  • subsEndPointRatePolicing sipCause <value>  SIP cause code to map SUBSCRIBE Endpoint CAC default error response.
  • subsRatePolicing sipCause <value> – SIP cause code when SUBSCRIBE message rate exceeds IP trunk group's maximum configured value.

  • subsTGLimit sipCause <value> – SIP cause code when current Subscription on IP trunk group exceeds maximum configuration limit.

 

The sipCause range for the above cause codes is 300-606.


  

  • No labels