In this section:
Overview
The ERE (Embedded Route Engine) supports number translations based on host part (contains a fully-qualified domain name) of the SIP headers. IP addresses format is not supported for host-part lookup. It is always recommended to use the fully-qualified domain name. The SBC retrieves the destination domain from the various SIP headers and sends it to ERE as part of the policy request. The domain name look-up is case insensitive and partial matches are supported, while first priority is always for full match.
The supported destination domain SIP headers are:
- INVITE Message,
R-URI Header - INVITE Message,
TO Header - 3XX Message,
Contact Header
How to Configure CNAM (ENUM) Dip Criteria
The following steps outline how to configure CNAM (ENUM) Dip Criteria
- Configuring CNAM (ENUM) Trigger Criteria
- Configuring ENUM Service
- Enabling Service Type
- Configuring ENUM Domain Name and Address
- Configuring Private Domain Name
- Configuring Ip Access Control List
Configuring CNAM (ENUM) Trigger Criteria
set profiles digitParameterHandling numberTranslationCriteria CR1 calledUri ABC.com Sonus_NULL Sonus_NULL Sonus_NULL lookupType enumCnam commit
Configuring ENUM Service
set global servers enumService ENUMSER1 criteria triggerCriteria CR1 commit
Configuring Service Type
set global servers enumService ENUMSER1 defaultTreatment applyFinalTreatment serviceType cnam flags active enable commit
Configuring ENUM Domain Name and Address
set global servers enumDomainName ims.ABC.com forwardersData 1 forwarderIP 10.54.212.202 forwarderDescription test commit
Configuring Private Domain Name
set global servers enumService ENUMSER1 enumDefinitions privateDomainNameForEnumLookups ims.ABC.com commit
set global servers enumDomainNameLabel DEFAULT_ZONE_LABEL enumDomainNameId ims.ABC.com commit
Configuring Ip Access Control List
set addressContext default ipAccessControlList rule ENUM sourceIpAddress 10.54.212.202 action accept sourceAddressPrefixLength 32 precedence 1 state enabled commit
Overview
Content Tools