The
Run the
From the Tasks tab of the WebUI, go to SBC Easy Setup (navigation pane) and click Easy Config Wizard. As the wizard runs, it directs you through three configuration steps:
Step 1. Set the following parameters to describe the topology for the telephony service provider and user ends of the scenario:
Step 2. Configure the items required for the endpoints selected; fields display based on the endpoint selection in Step 1.
Step 3. The Easy Config validates the final parameters and displays a read-only summary of the configuration that the wizard will apply when you click Finish at Step 3. Before you click Finish, you can return to previous steps to make adjustments to the data summarized.
The wizard displays the following buttons for navigation:
Easy Config validates data at each step of the wizard. The wizard displays messages and blocks navigation to the next step when the data and selections for the current step are not valid.
You can also navigate through the Wizard by clicking the Step buttons. However, steps beyond the current step are disabled until the data for current step is validated successfully. Click on the step of your choice to view prior Step fields.
The following application scenarios are configurable from the drop-down list of the Application field (Step 1).
After you select a scenario, the corresponding template displays.