Steps for SBC SWe Installation on KVM Hypervisor

Create an IP plan

An IP Plan helps you to gather configuration details, such as the IP addresses the management port, HA port and two media ports for SBC SWe Virtual Machine (VM). The media ports are used for SIP and RTP traffic.

Refer to Creating an IP Plan for SBC SWe for help with completing an IP plan.

Configure your SWe environment

Before creating a Virtual Machine and installing SBC SWe images, you must create the virtual/cloud environment on the host or hosts allocated for the SBC SWe.

To get started, refer to the page applicable to your environment:

• • • VMware: Configuring Your Network for SBC SWe on VMware
    • KVM: Creating and Linking Network Bridge

Create a VM for SBC

This step involves creating a VM and allocating resources, and configuring a datastore to contain the  Operating System (OS) and Application software.

Refer to the page applicable to your environment for details:

• • • VMware
      • Creating Virtual Machine using vNetwork Standard Switch (vSwitch)
      • Creating Virtual Machine using vNetwork Standard Switch (vSwitch) in VMware ESXi Web Client
      • Creating Virtual Machine using vSphere Distributed Switch
    • KVM
      • Creating a New SBC SWe Instance on KVM Hypervisor
      • Creating a New SBC SWe Instance with PCI Pass-Through Device

Install SBC Application

Refer to the page applicable to your environment for step-by-step instructions to install the SBC application from the Embedded Management Application (EMA):

• • • Installing SBC Application on VMware
    • Installing SBC SWe on KVM Hypervisor

Install License Files

Install SBC licenses using the EMA. Refer to System Administration - License Management and Node-Locked Licensing for details.

Configure your system

You are now ready to configure your SBC SWe for traffic!

A large amount of information is needed to configure your platform. Use the IP Plan you created in step 1 to help manage this information.

If you would like to set up a basic call flow to test your configuration, refer to How to Set up a Basic Call Flow.